HDPE Fittings

Molded and fabricated HDPE fittings produced and tested in accordance with ASTM standards.

At ISCO, we manufacture molded and fabricated fittings HDPE fittings for use in a variety of applications.

All of our fabricated fittings—elbows, tees, reducing tees, and end caps are produced and tested in accordance with ASTM F2206 – “Standard Specification for Fabricated Fittings of Butt-Fused Polyethylene Plastic Pipe.” ASTM F2206 places very specific requirements on fabricated fittings in two areas –the type of HDPE pipe, fittings and plate or sheet stock used in the manufacturing of pressure-rated fabricated fittings; and the testing required for qualifying fabricated fittings.

Elbows

Fabricated elbows come in 2-inch through 63-inch size configurations, as well as 2-, 3- and 5-mitered bend options. In addition to 22.5-, 45- and 90-degree configurations. Molded elbows are available in 3/4-inch to 12-inch size ranges, as well as 45- and 90-degree configurations.

Tees

Molded and fabricated tees are available in 3/4-inch to 63-inch size configurations, as well as line tees, reducing tees, and branch saddle reducing tees depending on your design specifications.

Reducers

Our concentric and eccentric reducers range from 1-inch x ½-inch to 10-inch x 8-inch.

Wyes

Lateral wyes and cleanout wyes available in 45-degree, 2- through 63-inch size ranges. Molded and fabricated wyes manufactured to your design specifications.

End Caps

We offer end caps in sizes ranging from 3/4-inch to 54-inch. Each endcap is designed to your project specifications for easy installation.

Branch Saddles

Branch saddles are available in sizes from 1-1/4-inch to 12-inch sizes. Also, our MTD line is the only brand to offer 4-inch, 6-inch and 8-inch size-on-size branch saddles for the gas distribution industry.

HAVE A QUESTION OR PROJECT TO DISCUSS? GET IN TOUCH!

CTA Contact

TOP